PHY状态机分析

原标题：PHY状态机分析

PHY的12种状态

enum phy_state {
PHY_DOWN = 0, //关闭网卡
PHY_STARTING, //PHY设备准备好了，PHY driver尚为准备好
PHY_READY, //PHY设备注册成功
PHY_PENDING, //PHY芯片挂起
PHY_UP, //开启网卡
PHY_AN, //网卡自协商
PHY_RUNNING, //网卡已经插入网线并建立物理连接，该状态可切换到PHY_CHANGELINK
PHY_NOLINK, //断网，拔掉网线
PHY_FORCING,//自动协商失败，强制处理（读phy状态寄存器，设置速率，设置工作模式）
PHY_CHANGELINK, //LINK检查，当物理连接存在时切换到PHY_RUNING，物理连接不存在时切换到PHY_NOLINK
PHY_HALTED, //网卡关闭时，PHY挂起
PHY_RESUMING //网卡开启时，PHY恢复
};


PHY状态机

PHY指PHY芯片，负责数据传送与接收所需要的电与光信号、线路状态、时钟基准、数据编码和电路等,并向数据链路层设备提供标准接口。
MAC指MAC芯片，属于数据链路层，提供寻址机构、数据帧的构建、数据差错检查、传送控制、向网络层提供标准的数据接口等功能。
PHY_DOWN: phy、phy driver、mac都没准备好

1. 如果phy driver被集成在内核中，PHY.probe后，phydev状态为PHY_READY。


2. 如果phy driver被未集成在内核中，PHY.probe后，phydev状态为PHY_STARTING。

PHY_READY：phy、phy driver已经就绪，mac未准备好
当MAC层加载时，在PHY.start后，phydev状态切换为PHY_UP。

PHY_STARTING：phy准备就绪，phy driver、mac未准备好

1. 当MAC加载时，PHY.start后，phydev状态为PHY_PENDING。


2. 当phy driver加载时，phydev状态为PHY_READY。

PHY_PENDING：phy、mac准备就绪,phy driver未准备好
当phy dirver加载后，phdev状态为PHY_UP

上图中0-->1-->2-->4、0-->2-->4代表phy、phy dirver、mac顺序加载。
0-->1-->3-->4代表phy、mac、phy driver顺序加载。

PHY_UP：phy、phy driver、mac准备就绪
当前状态将启动自动协商，若启动成功则进入PHY_AN，若启动失败则进入PHY_FORCING。

PHY_AN：网卡自协商模式，检测自协商是否完成。
先判断物理链路的状态，如果未LINK则进入PHY_NOLINK，如果LINK则判断自协商是否完成，
自协商完成进入PHY_RUNNING，若自协商超时则重新开启自协商。

PHY_FORCING：强制协商
读link和自协商状态寄存器，如果状态正常则进入PHY_RUNNING模式。

PHY_NOLINK：物理链路未连接
判断物理链路状态，如果LINK，再判断是否支持自协商，若支持待自协商完成后进入PHY_RUNNING模式，
若不支持，直接进入PHY_RUNNING模式。若自协商处于挂起状态，则进入PHY_AN模式。

PHY_RUNNING：正常运行中
获取当前link状态，当link状态发生改变时，进入PHY_CHANGELINK模式。

PHY_CHANGELINK：检查物理链路
物理链路link时，切换到PHY_RUNNING，非LINK时切换到PHY_NOLINK。

PHY_HALTED：网卡关闭phy_stop
挂起phy
PHY_RESUMING: 网卡启用phy_start
恢复phy

phy_state_machine是PHY的状态机函数

/**
* phy_state_machine - Handle the state machine
* @work: work_struct that describes the work to be done
*/
void phy_state_machine(struct work_struct *work)
{
struct delayed_work *dwork = to_delayed_work(work);
struct phy_device *phydev =
container_of(dwork, struct phy_device, state_queue);
bool needs_aneg = false, do_suspend = false;
enum phy_st文章来源地址164498.htmlate old_state;
int err = 0;
int old_link;
mutex_lock(&phydev->lock);
old_state = phydev->state;
if (phydev->drv->link_change_notify)
phydev->drv->link_change_notify(phydev);
switch (phydev->state) {
case PHY_DOWN:
case PHY_STARTING:
case PHY_READY:
case PHY_PENDING:
break;
case PHY_UP:
needs_aneg = true;
phydev->link_timeout = PHY_AN_TIMEOUT;
break;
case PHY_AN:
err = phy_read_status(phydev);
if (err <0)
break;
/* If the link is down, give up on negotiation for now */
if (!phydev->link) {
phydev->state = PHY_NOLINK;
netif_carrier_off(phydev->attached_dev);
phydev->adjust_link(phydev->attached_dev);
break;
}
/* Check if negotiation is done. Break if there's an error */
err = phy_aneg_done(phydev);
if (err <0)
break;
/* If AN is done, we're running */
if (err > 0) {
phydev->state = PHY_RUNNING;
netif_carrier_on(phydev->attached_dev);
phydev->adjust_link(phydev->attached_dev);
} else if (0 == phydev->link_timeout--)
needs_aneg = true;
break;
case PHY_NOLINK:
if (phy_interrupt_is_valid(phydev))
break;
err = phy_read_status(phydev);
if (err)
break;
if (phydev->link) {
if (AUTONEG_ENABLE == phydev->autoneg) {
err = phy_aneg_done(phydev);
if (err <0)
break;
if (!err) {
phydev->state = PHY_AN;
phydev->link_timeout = PHY_AN_TIMEOUT;
break;
}
}
phydev->state = PHY_RUNNING;
netif_carrier_on(phydev->attached_dev);
phydev->adjust_link(phydev->attached_dev);
}
break;
case PHY_FORCING:
err = genphy_update_link(phydev);
if (err)
break;
if (phydev->link) {
phydev->state = PHY_RUNNING;
netif_carrier_on(phydev->attached_dev);
} else {
if (0 == phydev->link_timeout--)
needs_aneg = true;
}
phydev->adjust_link(phydev->attached_dev);
break;
case PHY_RUNNING:
/* Only register a CHANGE if we are polling or ignoring
* interrupts and link changed since latest checking.
*/
if (!phy_interrupt_is_valid(phydev)) {
old_link = phydev->link;
err = phy_read_status(phydev);
if (err)
break;
if (old_link != phydev->link)
phydev->state = PHY_CHANGELINK;
}
/*
* Failsafe: check that nobody set phydev->link=0 between two
* poll cycles, otherwise we won't leave RUNNING state as long
* as link remains down.
*/
if (!phydev->link && phydev->state == PHY_RUNNING) {
phydev->state = PHY_CHANGELINK;
dev_err(&phydev->dev, "no link in PHY_RUNNING\n");
}
break;
case PHY_CHANGELINK:
err = phy_read_status(phydev);
if (err)
break;
if (phydev->link) {
phydev->state = PHY_RUNNING;
netif_carrier_on(phydev->attached_dev);
} else {
phydev->state = PHYwww.yii666.com_NOLINK;
netif_carrier_off(phydev->attached_dev);
}
文章来源地址164498.html
phydev->adjust_link(phydev->attached_dev);
if (phy_interrupt_is_valid(phydev))
err = phy_config_interrupt(phydev,
PHY_INTERRUPT_ENABLED);
break;
case PHY_HALTED:
if (phydev->link) {
phydev->link = 0;
netif_carrier_off(phydev->attached_dev);
phydev->adjust_link(phydev->attached_dev);
do_suspend = true;
}
break;
case PHY_RESUMING:
if (AUTONEG_ENABLE == phydev->autoneg) {
err = phy_aneg_done(phydev);
if (err <0)
break;
/* err > 0 if AN is done.
* Otherwise, it's 0, and we're still waiting for AN
*/
if (err > 0) {
err = phy_read_status(phydev);
if (err)
break;
if (phydev->link) {
phydev->state = PHY_RUNNING;
netif_carrier_on(phydev->attached_dev);
} else {
phydev->state = PHY_NOLINK;
}
phydev->adjust_link(phydev->attached_dev);
} else {
phydev->state = PHY_AN;
phydev->link_timeout = PHY_AN_TIMEOUT;
}
} else {
err = phy_read_status(phydev);
if (err)
break;
if (phydev->link) {
phydev->state = PHY_RUNNING;
netif_carrier_on(phydev->attached_dev);
} else {
phydev->state = PHY_NOLINK;
}
phydev->adjust_link(phydev->attached_dev);
}
break;
}
mutex_unlock(&phydev->lock);
if (needs_aneg)
err = phy_start_aneg(phydev);
else if (do_suspend)
phy_suspend(phydev);
if (err <0)
phy_error(phydev);
dev_dbg(&phydev->dewww.yii666.comv, "PHY state change %s -> %s\n",
phy_state_to_str(old_state), phy_state_to_str(phydev->state));
qu文章来源站点https://www.yii666.com/eue_delayed_work(system_power_efficient_wq, &phydev->state_queue,
PHY_STATE_TIME * HZ);
}


来源于：PHY状态机分析